エスカレード07 について質問です。 タイヤ圧の警告灯が出ていた ので、タイヤ圧を確認し 空気を入れたのですが 警告灯が消えません。 なにか他にもあるのでしょうか？

Answer 1

TPMSのリセットをしてください。
●How to Use the Tire Pressure Monitor System -
Cadillac Escalade Luxury SUV
https://www.youtube.com/watch?v=uV8GVaG-H2Y
●TPMSのリセット
1. Set the parking brake.
2. Turn the ignition switch to RUN with the off.
3. Using the DIC, press the vehicle information
button until the PRESS / TO RELEARN
TIRE POSITIONS message displays.
4. Press the set/reset button. The horn will
sound twice to indicate the TPMS receiver
is ready, and the TIRE LEARNING ACTIVE
message will display.
5. Start with the driver’s side front tire.
6. Remove the valve cap from the valve
cap stem. Activate the TPMS sensor by
increasing or decreasing the tire’s air
pressure for five seconds, or until a horn
chirp sounds. The horn chirp, which make
take up to 30 seconds to sound, confirms
that the sensor identification code has been
matched to this tire and wheel position.
To decrease air-pressure out of a tire you
can use the pointed end of the valve cap,
a pencil-style air pressure gage, or a key.
ーーーーーーーーーーーーーーーーーーーーー
7. Proceed to the passenger’s side front tire,
and repeat the procedure in Step 6.
8. Proceed to the passenger’s side rear tire,
and repeat the procedure in Step 6.
9. Proceed to the driver’s side rear tire, and
repeat the procedure in Step 6.
10. After hearing the confirming horn chirp for
the driver’s side rear tire, the horn chirp
will sound two more times to signal the
tire learning mode is no longer active.
Turn the ignition switch to LOCK.
11. Set all four tires to the recommended
air pressure level as indicated on the Tire
and Loading Information label.
12. Put the valve caps back on the valve stems
The spare tire does not have a TPMS sensor.
If you replace one of the road tires with the spare,
the SERVICE TIRE MONITOR message will be
displayed on the DIC screen. This message should
go off once you re-install the road tire containing
the TPMS sensor

質問者からのお礼コメント

ありがとうございます！